Dongguan, China Vertical injection molding machines Technical selection starts with your part →
Solution · Machine replacement

Machine replacement

An old machine still makes the part, and the existing mold has to keep running on whatever replaces it.

Zanyang double sliding table vertical injection molding machine

The situation

The machine on the floor still produces, but spares are hard to find, the control is obsolete, the cycle drifts or the original supplier no longer answers. The plant cannot stop production long enough to learn a new platform from zero. The first risk named is usually that the existing mold will not fit, or will not run the same way.

Suitable when

It fits when the product and the mold stay the same; when the running process is documented well enough to repeat; and when the reason to change is reliability, support or control rather than a new part.

When it is not needed

It is not needed when the old machine only needs a control board, a screw or a seal kit. If the product is about to change enough that the mold is rebuilt anyway, that is a new-project decision, not a swap.

Production logic

The existing machine and mold are read first: platen, mold thickness, opening stroke, ejector and nozzle position, utilities and floor space. The settings that have to be reproduced are agreed and written down. The new machine is built against the mold and tested with it before shipment. On site it is installed, connected and run on the documented process, and the part is compared with the approved sample.

What has to be confirmed first

These are worked out with you before a structure is named. Send what you have; the rest is settled in review, before a sheet or a price exists.

  1. Nameplate and configuration of the machine being replaced.
  2. Mold drawings with width, length, shut height, weight, ejector and nozzle position.
  3. The running process sheet, and the approved sample the part is judged against.
  4. Site data: voltage, frequency, air, cooling water and floor space.
  5. Access route and rigging limits for the new machine.
  6. Which other products the machine has to run in future.

What we do not promise yet

We do not promise a cycle identical to the old machine before both are measured under the same conditions, and an existing mold may still need changes. Compatibility is checked against real drawings and the real tool, not assumed from a tonnage figure.

Anything not agreed in writing before the test is not part of the scope.

Machines

Applications

  • Automotive components

    Small parts defined by an insert or sealing face, where one configuration and one acceptance record must repeat.

Send the part, the insert and the cycle.

The first review says whether this is the structure for your part, and if it is not, which one is. Nothing here is agreed until it is written down against your own mold.

Start a technical review