Cable and plug overmolding
A terminated cable is laid in an open lower mold and the plug body is molded around it.
Read the applicationSix production problems that a vertical clamp answers, and the data that decides the structure behind each one.
A terminated cable is laid in an open lower mold and the plug body is molded around it.
Read the applicationTerminals stand upright in the lower cavity and the housing is molded around them, so each pin is visible seated.
Read the applicationA nut or bracket sits in the lower half while plastic is molded around it, so load stays in metal.
Read the applicationSmall parts defined by an insert or sealing face, where one configuration and one acceptance record must repeat.
Read the applicationA housing, coil or cable end is enclosed by a short flow, using a barrel matched to a small shot.
Read the applicationAutomation starts at how the insert arrives, is oriented and is checked, not at the robot that picks it.
Read the applicationA supplier that only sells one structure will always find a reason for it. These are the cases where we say so first.
An insert that shifts, a cable that gets pinched, a cycle that will not come down, a mold that will not fit the next machine. Those are the problems a selection is actually made of.