Dongguan, China Vertical injection molding machines Technical selection starts with your part →
Application · Connector & terminal

Connector and terminal insert molding

Terminals stand upright in the lower cavity and the housing is molded around them, so each pin is visible seated.

Application group
Connector & terminal
Insert type
Stamped terminals, contact pins, contact carriers and metal shells.
Electronic connectors, switches and overmolded components on a workbench

The part

PCB headers, terminal blocks, and board-to-board or wire-to-board connector bodies. Crimp terminal assemblies and contact carriers molded into a housing. Seal rings and busbar end caps formed over a metal contact.

Common materials

PBT, PA6/PA66, PPS and PPA for housings, often glass-filled where pin pitch is fine and walls are thin. The polymer has to bond to or seal against the plating on the terminal.

Why a vertical clamp

Terminals are small, upright and easy to tilt, and a tilted pin is only visible while the tool is open. A vertical clamp leaves the lower half flat and exposed, so the whole pin array is in view from above and can be checked before the upper half descends. Gravity holds the pins in their locating holes instead of letting them hang, and the closing motion travels along the pin axis rather than across it.

How the insert is loaded

Terminals arrive in a carrier strip or a tray and are seated on locating pins in the lower cavity, then checked for full seating and tilt before clamp close. Manual loading with a nest gauge serves the smaller arrays; pick-and-place from carrier tape takes over when the pin count per shot is high.

What the buyer is really asking

Whether pin height and position hold over a long run rather than over a few shots. Whether plastic flashes at the terminal exit, and how the housing seals against the plating. Whether a change in the terminal stamping forces the tool to be re-qualified.

Structure that usually follows

Data that decides it

  1. Terminal drawing with base material, plating and the surfaces that must stay free of plastic.
  2. Part drawing with pin pitch, wall thickness, cavity count and the tolerance that matters most.
  3. Housing material, including whether it is glass-filled, halogen-free or flammability rated.
  4. Mold status: existing tool dimensions, gate type and ejector layout, or a new tool in design.
  5. The electrical or dimensional test the finished connector has to pass.
  6. Target cycle, annual volume and whether loading will stay manual.

What can go wrong

A terminal can move once injection pressure arrives, thin walls between contacts can short-shot, flash can form at the shut-off around the pin, and locating pins wear until the array no longer sits at the same height. What appears is decided by pin support in the cavity, gate and runner layout, wall thickness, injection profile, cavity count and how the terminal is held during clamp-up.

Naming a risk is not the same as removing it: which of these applies to your part is settled in technical review.

Related solutions

Tell us the part and the insert

A photograph of the part with the insert in place, the plastic grade and the mold size start the review. Which of the points above applies to your part is settled there, not on this page.

Send this part for review